Water Heater Replacement – Cedar Hills, Beaverton OR
True Flow Plumbing provides water heater replacement throughout Cedar Hills, one of Beaverton's oldest established neighborhoods. Cedar Hills homes built in the 1950s and 1960s present a specific set of conditions: utility spaces that were designed around the equipment of that era, gas lines that have been in service for six decades, and water heaters that may be on their second or third replacement cycle. When a Cedar Hills water heater fails — or starts showing the signs that failure is coming — we know what to expect when we open that utility closet door.
What Makes Cedar Hills Water Heater Replacement Different
Cedar Hills was developed primarily between 1953 and 1968 — a tract housing era when utility rooms were sized for the equipment of the time and gas lines were run for the original appliances. Sixty-plus years later, those utility spaces haven't grown, but the equipment options have. Most Cedar Hills homes have a standard 40 or 50-gallon tank in a dedicated closet or corner of the garage, and replacement is straightforward. What we pay attention to in homes this age: the condition of the gas supply line and shutoff, whether the flue venting is still properly configured, and whether the T&P relief valve and drain pan are up to current standards.
Signs Your Cedar Hills Water Heater Needs Replacement
- Hot water runs out faster than it used to
- Rust-colored or discolored water at the hot tap
- Rumbling or popping sounds when heating — sediment buildup
- Pilot light keeps going out on older gas units
- Visible corrosion or moisture around the base of the unit
- Unit is 10 or more years old and any of the above are present
What We Install in Cedar Hills
- Rheem 40 and 50-gallon natural gas tank water heaters — most common replacement in Cedar Hills
- Rheem tankless gas units where space is limited and gas line capacity supports it
- Full assessment of existing gas supply line and shutoff condition before installation
- Flue and venting inspection — older Cedar Hills homes sometimes have venting that needs updating
- T&P relief valve and drain pan replaced or confirmed to current standard
- Old unit hauled away — no extra charge
- Most installations completed same day
Frequently Asked Questions
My Cedar Hills home was built in 1962. What should I know about water heater replacement?
The main things we check on homes from that era: the gas supply line condition and shutoff valve — 60-year-old shutoffs sometimes don't close fully and need replacement before we install the new unit. The flue venting — older B-vent configurations need to be confirmed for proper draft and clearance. And the space itself — we verify the new unit fits the existing footprint before we bring it in. None of these are typically large issues, but they're what separates a clean installation from a problem discovered mid-job.
Should I upgrade to tankless in my Cedar Hills home?
Tankless makes sense in Cedar Hills homes where the utility space is genuinely tight, or where the household has high hot water demand from multiple simultaneous users. The requirement is adequate gas line capacity — tankless units need significantly more BTUs than tank heaters, and some older Cedar Hills gas lines need upsizing to support them. We check line capacity before recommending tankless so you're not surprised mid-installation.
Do you serve all of Cedar Hills?
Yes — Cedar Hills Park, Cedar Hills Crossing area, and all residential streets throughout the Cedar Hills neighborhood. We also serve the adjacent Beaverton neighborhoods including Oak Hills, Raleigh Hills, and downtown Beaverton.
Cedar Hills & Beaverton Neighborhoods We Serve
All Water Heater Services – Beaverton → | Drain Cleaning – Cedar Hills → | Sewer Scope →
Water Heater Replacement in Cedar Hills?
Call us. We'll assess the existing setup and install the right unit for your home — same day in most cases.